Dinstein (I.) Generalized Morphological Operators Applied to Map-Analysis SSPR-96, 1996. ,
Measurement of Surface Tension and Contact Angle using Entropic Edge Detection Measurement Science and Technology, pp.288-298, 2001. ,
Application of wavelet transform to hologram analysis: three-dimensional location of particles, Optics and Lasers in Engineering, vol.33, issue.6, pp.409-421, 2000. ,
DOI : 10.1016/S0143-8166(00)00050-6
Jones (P.L.) Comparison of the Various Correlations for Spray Penetration SAE Paper no. 720776, 1972. ,
Leipertz (A.) Investigation of the Primary Spray Breakup Close to the Nozzle of a Common ? Rail High Pressure Diesel Injection System SAE Paper no, 1799. ,
Internal Combustion Engine Fundamentals, 1988. ,
Arai (M.) Structure of Fuel Sprays in Diesel Engines SAE Paper no, 1990. ,
Fundamental Spray Combustion Mechanism and Structures of Fuel Sprays in Diesel Engines Mechanics Combustion of Droplets and Sprays, 1995. ,
Lee (E.) Diesel Spray Atomization Model Considering nozzle Exit Turbulence Conditions Atomization and Sprays, pp.453-469, 1998. ,
Arai (M.) Diesel Spray Impinging on a Flat Wall Part II : Volume and Average Air ? Fuel Ratio of an Impingement Diesel Spray Atomization and Sprays, pp.753-768, 2002. ,
Atomization and Sprays Hemisphere Publ, Corp, pp.0-89116, 1989. ,
Hidaka (N.) Evaluation of the Accuracy of the Particule Displacement Measurement Based on Digital Holography The fifth JSME-KSME Fluids Engineering Conference, pp.1-5, 2002. ,
Potential of Digital Holography in Particle Measurement Optics & Laser Technology, Naber (J.), Siebers (D.L) Effect of Gas Density and Vaporization on Penetration and Dispersion of Diesel Sprays SAE paper no. 960034, pp.567-574, 1996. ,
A Threshold Selection Method from Gray Level Histograms IEEE Trans, pp.62-66, 1979. ,
A.) Fluid Dynamics and Transport of Droplets and Sprays, pp.0-521, 1999. ,
URL : https://hal.archives-ouvertes.fr/in2p3-00491644
Compressibility of Diesel and Methanol Fuels at Low Temperatures SAE paper no 890055, 1989. ,
le carburant ne peut pas s'échapper de la chambre de commande (42) vers le circuit de retour ,
les forces sont en équilibre, l'aiguille obture le passage au niveau de son siège, le ressort de la vanne (33) presse la bille (12) contre son siège ,