279 articles – 2094 Notices  [english version]
Fiche concise Communications avec actes
DESIGN, FABRICATION AND CHARACTERIZATION OF A PIEZOELECTRIC MICROGENERATOR INCLUDING A POWER MANAGEMENT CIRCUIT
Marzencki M. et al
Dans Symposium on Design, Test, Integration and Packaging of MEMS/MOEMS - DTIP 2007, Stresa, lago Maggiore : Italie (2007) - http://hal.archives-ouvertes.fr/hal-00257715
Liste des fichiers attachés à ce document : 
PDF
dtip07_1084.pdf(415.6 KB)
M. Marzencki1, Y. Ammar1, S. Basrour1
1 :  TIMA - Techniques of Informatics and Microelectronics for integrated systems Architecture
http://tima.imag.fr/
CNRS : UMR5159 – Université Joseph Fourier - Grenoble I – Institut National Polytechnique de Grenoble (INPG)
46 Av Félix Viallet 38031 GRENOBLE CEDEX 1
France
Informatique/Autre
Informatique/Architectures Matérielles
DESIGN, FABRICATION AND CHARACTERIZATION OF A PIEZOELECTRIC MICROGENERATOR INCLUDING A POWER MANAGEMENT CIRCUIT
We report in this paper the design, fabrication and experimental characterization of a piezoelectric MEMS microgenerator. This device scavenges the energy of ambient mechanical vibrations characterized by frequencies in the range of 1 kHz. This component is made with Aluminum Nitride thin film deposited with a CMOS compatible process. Moreover we analyze two possible solutions for the signal rectification: a discrete doubler-rectifier and a full custom power management circuit. The ASIC developed for this application takes advantage of diodes with very low threshold voltage and therefore allows the conversion of extremely low input voltages corresponding to very weak input accelerations. The volume of the proposed generator is inferior to 1mm3 and the generated powers are in the range of 1µW. This system is intended to supply power to autonomous wireless sensor nodes.
Anglais
04/2007

Symposium on Design, Test, Integration and Packaging of MEMS/MOEMS
internationale
04/2007
350-353
TIMA Editions

DTIP 2007
04/2007
Stresa, lago Maggiore
Italie

Micro power generators and micro energy sources
Submitted on behalf of EDA Publishing Association (http://irevues.inist.fr/EDA-Publishing)