160 articles – 197 Notices  [english version]
Fiche détaillée Communications avec actes
ECSCRM, Newcastle upon Tyne : Royaume-Uni (2006)
Use of Graphite Cap to Reduce Unwanted Post-Implantation Annealing Effects in SiC
Erwan Oliviero1, Mihai Lazar1, Heu Vang1, Christiane Dubois2, Pierre Cremilleu3, Jean-Louis Leclercq3, Jacques Dazord4, Dominique Planson1

6H and 4H-SiC epilayers were Al-implanted at room temperature with multiple energies (ranging from 25 to 300 keV) in order to form p-type layers with an Al plateau concentration of 4.5×1019 cm-3 and 9×1019 cm-3. Post-implantation annealing were performed at 1700 or 1800 °C up to 30 min in Ar ambient. During this process, some samples were encapsulated with a graphite (C) cap obtained by thermal conversion of a spin-coated AZ5214E photoresist. From Atomic Force Microscope measurements, the roughness is found to increase drastically with annealing temperature for unprotected samples while the C capped samples show a preservation of their surface states even for the highest annealing temperature. After 1800°C/30 min annealing, the RMS roughness is 0.46 nm for the lower fluence implanted samples, slightly higher than for unimplanted samples (0.31 nm). Secondary Ion Mass Spectroscopy measurements confirm that the C cap was totally removed from the SiC surface. The total Al-implanted fluence is preserved during postimplantation annealing. A redistribution of the Al dopants is observed at the surface which might be attributed to Si vacancy-enhanced diffusion. An accumulation peak is also observed after annealing at 0.29 9m, depth corresponding to the amorphous/crystalline interface that was determined on the as-implanted samples by Rutherford Backscattering Spectroscopy in channeling mode. The redistribution of the dopants has an impact on their electrical activation. A lower sheet resistance (Rsh= 8 k_) is obtained for samples annealed without capping than for samples annealed with C capping (Rsh= 15 k_ ).
1 :  Ampère
2 :  LPM - Laboratoire de physique de la matière
3 :  INL - Institut des nanotechnologies de Lyon - Site d'Ecully
4 :  LMI - Laboratoire des Multimatériaux et Interfaces
Graphite cap – Post-implantation annealing – Dopants – Diffusion – Ion implantation